A new small project, 3d print TinTins rocket to the moon with a single extruder printer. I found this model https://www.thingiverse.com/thing:22547 on thingiverse. I printed this rocket with white PLA with no infill whatsoever, layerhight 0.2 mm. After printing I sanded the model with fine sandpaper and spray painted it with primer.Then I filled the remaining gaps and holes with (in my case) brown woodfiller. Sanded it again and primed it again. With a few coats of red lacquer I prepared the model for the white parts of the rocket. I used washi tape for taping off the white parts, and used a paintbrush and white paint for the white pieces. I finished the model off with some varnish. For the Dutch readers NEVER use paint from the Action 🙁
